Repairs and maintenance

Maintenance of faucets:

Maintenance of the faucet depends on how hard your water is.
It would be a good idea to check the mineral content or if there is a coating in the kettle.
If there is scale after a few boilings, maintenance of the faucet will be more difficult.
If the water is very hard, consider installing a softener. Hard water can significantly shorten the life of the cartridge and the faucet surface.
No matter what faucet cleaning product you choose, rinsing it once a week is definitely not enough.
You should give your faucets more thorough care two to three times a week.

The cleaning product is not applied by spraying directly onto the faucet. Because it seeps into the joints and under the paint, where a chemical reaction occurs and the protective layer of the paint is damaged. The paint then peels off and causes undesirable visual changes to the surface finish.
The product must be properly maintained. We recommend cleaning our products with water only, but if it is necessary to use a cleaning agent, we apply it only to a microfiber cleaning cloth.
For cleaning, use designated chemicals that do not contain hydrochloric, formic and phosphoric acid.
Do not use vinegar solution on colored batteries.
Then rinse the battery with clean water and dry it with a dry and clean microfiber cloth.
Residues of cosmetic products can also damage the battery, they must be carefully removed with water.

Before starting the operation, it is necessary to turn off the water supply
Remove the colored markings of hot and cold from the battery lever water
Under this marking you will find a threaded screw with a hexagon for a 2.5mm Allen key
Unscrew this screw and remove the lever from the faucet
Remove the cartridge pressure nut cover by hand
Then loosen the brass nut (key no. 27, NIL key no. 24), which presses the cartridge in
Remove the cartridge from the faucet, clean the contact surfaces in the faucet and insert a new cartridge into the cleaned faucet so that the plastic pins of the cartridge fit into the drilled holes in the faucet body (pay attention to the correct position)
Then screw in and gently tighten the cartridge pressure nut
Then screw in the nut cover, put the lever on the cartridge, secure it with a threaded screw and click the marking water

Before starting the operation, it is necessary to turn off the water supply.
From the front of the handle (flower), unscrew the ring marked HOT/COLD (it is recommended that if it cannot be unscrewed, use a rubber glove)
Under this marking, you will find a screw for a Phillips screwdriver, which we unscrew
Then we slide the handle out of the milled face
By hand, unscrew the cover bell, under which you will find the top
This is done using Loosen the 17mm wrench, unscrew it from the battery and replace it with a new one.
After replacing the battery, we assemble it according to the previous steps in reverse order.
The battery seats may come loose. Therefore, it is necessary to tighten them from the back of the nuts with an Allen key No. 10.

Libor Skopal

Bidet Shower Repair Guide:

If there is weak pressure in the overhead shower:

Replacing the switch in the hanger: